• Built-in Heat Sink
• Voltage Spike Protection
• Static Discharge Protection
• Zero Current Draw Unless Triggered
• Prevents Misfires Due To Condensation, Grease, etc
• Wiring and T-Connectors Included
• Size: 35mm x 17mm x 8mm
• Voltage Range: 7v to 18v
• Power: Rated for 500amps peak, 60amps Continous

• Full Active Braking That Does Not Harm the Motor but Still Halts It Quickly
• Built-in 30amp Automatic Resetting Thermal Fuse
• Failure Of The Active Braking MOSFET Will Not Result Uncontrollable Firing.
• Low Heating Trip Circuit Prevents Damage Under Very Strong Short Circuit Conditions
• Size: 55mm x 13mm x 13mm

(ON ORDER) Notify Me When In Stock

• Fully Computer Controlled MOSFET Switching With Active Braking
• Normal, 3-Round Burst, and Semi-Only Operation
• 3-Round Burst Will Switch to Full Auto After Trigger Is Held For .04 Seconds
• Full PWM Motor Speed Control (Ability to Decrease and Increase ROF)
• Soft Start To Reduce Motor and Gear Wear
• Very Low Trigger Switch Current (~10mA)
• Self Diagnostics At Power and During Operation
• Mode, Burst Time, and Motor Speed are Programmed via Trigger Pulls
• Low Sound Level Motor Vibration Is Used To Signal User
• Size: 50.8mm x 16.5mm x 13.5mm
• Low Battery Warning: Low Battery Signal When Battery Drops to 85% of The Initial Voltage. Shutdown will occur when battery voltage is either under 7v or drops below 80% capacity. Highly recommended for use with Li-Po batteries.